For Bambu Lab A1 mini Purge Wiper dispensing component Collect and clean waste materials For A1 mini 3D printer Parts

Bambu Lab 3D Printer For A1 mini Purge Wiper dispensing component Collect and clean waste materials For A1 mini 3D printer Parts

Introduction: The A1mini discharge component is used to clean the waste generated by the hot end of the printer. Collect and clean waste materials during the printer preparation phase, pause recovery phase, and multi-color printing material replacement phase to ensure timely disposal of waste generated during the printing process.

Slide in the Purge Wiper unit into the slot at the end of the X-Axis from the back to the front. Install the 1*M3-12 screw (for purge wiper) from the accessory box to fix the Purge Wiper in place.

Note: After installing the purge wiper, it should be parallel to and not collide with the left edge of the heatbed, as shown in the

picture below: