Coloring hair Coleston 50 ml Max 304/5 Ghani dark

Colston hair dye tube with oil substitute, intense color and intense shine. Why do you choose the permanent hair dye cream Colston? Easy to use and does not fall out. Perfectly and permanently covers even the most resistant gray hair. Gives your hair a rich color and strong shine. Moisturizes your hair with oil substitute. How to use Colston Maxi Burgundy 304/5? 1- Prepare the coloring emulsion: place the contents of the tube in a non-metallic dish (plastic - glass - or porcelain), then add the developer liquid, and mix the two components with a coloring brush until you get a homogeneous coloring emulsion. Apply the emulsion to your hair immediately after mixing for the best coloring result. 2- Apply the dye emulsion: for the first dye, apply the dye emulsion to unwashed hair strand by strand using the dye brush. Make sure not to leave any part of it. Then comb your hair with a wide-tooth comb to ensure even distribution of the dye emulsion. To color the roots, divide your hair into sections, and first apply the dye emulsion section by section; after leaving it to soak for 20 minutes, comb the dye emulsion evenly to the ends of the hair. 3- Soaking time: soaking time is 30 minutes; for coloring roots, 20 minutes for roots and another 10 minutes for the entire hair. The color of the dye emulsion may change during soaking. 4- Final touch: condition your hair with oil substitute cream - rinse the hair until the water becomes clear (using no shampoo is recommended). - apply the oil substitute bag. - leave it for two minutes, then rinse again. A sensitivity test must be performed 48 hours before coloring your hair. You will need a cotton ball or cotton piece, a plastic container, and a plastic spoon. How to perform a skin sensitivity test for Colston Maxi dye? Open the dye tube cap. Hold the tube tightly without pressing it, directing the opening away from your face, then push the pointed end of the cap inside the seal. Then open the full appearance bottle cap. Hold the bottle tightly without pressing it, directing the opening away from your face. Mix a small amount of dye and appearance in a plastic container according to the mixing ratio shown on the box and dye tube. Close the dye tube and the appearance bottle tightly. Place the mixture on a test area about 1 cm square on your elbow crease. Leave it exposed for 45 minutes, then rinse with lukewarm water, gently dry your skin, and leave the test area untouched for 48 hours. Check the test area during the following 48 hours. If any signs of rash, redness, swelling, burning, itching, or similar appear, stop using the product, and consult a doctor before re-dyeing your hair. If these signs appear during the full 45-minute usage, rinse the hair immediately.