Fuse for Dash Camera, 70mai Hardwire Kit Type-C UP03 Type-C Converter for Dash Cameras 70mai to operate the camera 24/7 A510/ A810/ M500 70mai

70mai Micro Connector Cable for Camera through Car Battery A510/ A810/ M500 Cable connector for dash camera Type-C output (from 70mai) 70mai Hardwire Kit UP03 Functions and features: Activate parking mode The camera connected to this kit can record video while the car is parked, helping document any accidents or theft attempts when the vehicle is stationary. This feature adds an extra layer of security to your car. Battery protection from over-discharge This kit features over-discharge protection. It cuts power to the camera if the battery voltage drops to a certain level (11.4 volts for 12-volt batteries and 23.2 volts for 24-volt batteries). This feature protects the car battery from complete drain, preserving its lifespan. Easy and secure installation The 70mai Hardwire Kit UP03 provides an easy and safe way to install the dash camera without needing to change or modify the vehicle’s original wiring. This makes installation simple and efficient, allowing ordinary users to set up the system themselves. Cable specifications: Input voltage: 12V - 24V Output voltage: 5V - 2.4A Output current: 2.4A Standby current: 10mA Overcurrent protection: Yes Low battery voltage protection: Yes Please do not install unless by an electrical technician. Installation process: Locate the fuse box in your vehicle to connect the hard wires. You need to find the fuse box inside your car cabin. (Fuse box varies from vehicle to vehicle.) Connect the hard wire to the dash camera. Connect the micro USB port of the hard wire set to the dash camera and secure the wires inside your vehicle’s trim. When connected correctly, you will see the above alert when the vehicle is turned off. Incorrect connections will not activate the standby mode alert. Final setup and testing: Enable parking mode Tap Settings on the dash camera screen and go to Video Settings. Find the “Parking Monitoring” option. Enable it to activate standby mode. Test if standby mode works: When connected properly, you will see the above alert when the vehicle is turned off. Incorrect connections will not activate the standby mode alert. Troubleshooting: Cable not detected If you see the above message after wiring, please double-check the connections. If you believe the connections are correct, turn off your vehicle, then turn it back on after 5 minutes, and it will be detected. Compatible with the following 70mai Dash Cameras: Compatible with: 0mni, A510, A810, M500