40 centimeter RGB LED strip lights 5 volt ARGB PC case lamp LED bar SATA 3PIN desktop computer motherboard lighting decoration

Colmon Slim-LS40 5V ARGB small 4pin computer case LED light strip SATA 3PIN desktop computer LED strip 40 centimeters RGB accessories feature: The perfect ambient light strip can improve image clarity and relieve eye strain. Bring home theater like fun, very suitable for personal use. Small 4pin + 5V 3Pin ARGB male and female interface. Negative 5V 3-pin connector: Connect it to the motherboard 5V ARGB Shenguang synchronized interface, 5V 3-pin male connector: can be connected in series with other 5V ARGB products; small 4PIN interface: special interface for Kuyue brand controller 6P. When the motherboard does not support 5V ARGB 3-pin, you can buy a Kuyue 6P controller to use with it. Magnetic suction installation. Convenient, practical, beautiful, and can be strongly absorbed on the metal plate of the chassis, very convenient. 500 mm long wire is sufficient. The power supply line length is enough to meet the wiring requirements for large, medium, and small chassis. About the controller: If the buyer's motherboard does not support 5V ARGB, this controller can be used to achieve dimming. No motherboard support needed. Only needs to connect the computer power interface SATA. Through the built-in lighting mode of the controller, lighting control for 3-pin 5V ARGB products can be achieved. Multiple 5V ARGB products can be connected in series at the end after wiring to achieve lighting control of multiple 5V ARGB products. Note: This controller does not support connecting the motherboard program for light synchronization; this controller is not a universal controller and only supports products from this brand. If connected in the production line of other brands, it will burn out! Specifications: Brand: Colmon Model light strip: CM-LS40 Material light strip: ABS + magnet Number of bulbs: 24 Light strip interface type: 5V 4-pin * 2 + small 4-pin * 1 Light strip interface type: 5V ARGB Control interface type: SATA, 3pin Control wire length: 3pin: 160 (±10) mm / 6.3 (±0.39) inches; SATA; 500 (±10) mm / 19.7 (±0.39) inches Light strip length: about 500 mm / 19.7 inches Light strip size: 400*10*3 millimeters / 15.7x0.39x0.12 inches Light strip weight: 20 grams Controller weight: 20 grams Controller size: 46x22x9.5 millimeters / 1.8x0.87x0.37 inches Controller use: Click M to switch to the next lighting mode, which can rotate to switch the controller's lighting mode; click S to change the light change speed. There are 8 gears that can be cycled; long press the S key for 4 seconds to turn off the light, then long press for 4 seconds to turn on the light; click the C key to switch to other bright colors under the same pattern or reverse the light. Long press the C key for 5 seconds to switch the brightness. Brightness can be reduced across 6 gears (cycle switch). Note: AURASYNC from 12V 4-pin motherboard is not supported. Make sure to disconnect power and connect the cable, otherwise incorrect interface may cause a short circuit and burn the device! Due to screen differences and lighting effects, the actual color of the product may differ slightly from the color shown in the pictures. Thank you! Please allow a measurement deviation of 1-2 cm due to manual measurement. 1 × ARGB light strip or 1 × ARGB light strip 1 × controller