DSPPA DSP6011 6.5-inch Frameless Ceiling Speaker, 6W 100V
44.37ر.س
Product description
The DSPPA DSP6011 is a frameless 6.5-inch, 6W ceiling speaker with a 70V/100V transformer that clips into a 165 to 170mm hole. It is a practical choice for PA systems in schools, mosques, offices and malls.
====
The DSPPA DSP6011 is a frameless 6.5-inch ceiling speaker rated at 6W. It drops into a 165 to 170mm ceiling hole and holds itself in place with spring clips. A built-in 70V/100V transformer lets it work with central PA amplifiers in schools, mosques and offices, with dozens of units sharing one speaker line.
DSPPA DSP6011 specifications
These figures come from the product page and datasheet on DSPPA's official site:
- Power: 6W RMS.
- Taps: 3W or 6W on 70V, 6W on 100V.
- Sensitivity: 90±2dB; maximum SPL: 97±2dB.
- Frequency response: 110Hz to 15kHz.
- Cutout: 165 to 170mm; dimensions 190.5 × 70mm.
- Net weight: 0.6kg.
A frameless face for gypsum ceilings
The aluminum grille has a thin edge, so the speaker reads as a flat circle rather than a raised frame. At just 70mm deep, it fits most suspended ceilings where air-conditioning ducts leave little room above the tiles. DSPPA says the engineering plastic housing will not warp or fade over time. That quiet look matters in mosques and halls with decorative gypsum ceilings, where a raised frame would break the pattern.
Why 6W is enough for most rooms
A sensitivity of 90dB means 90 decibels at one meter from a single watt. At 6W the level rises by about 8dB, which matches the 97dB maximum SPL in the datasheet and is more than paging or soft music needs in a classroom or office with a standard ceiling height. Good coverage comes from enough speakers, not from more power per speaker.
Installation in four steps
DSPPA's datasheet sets out the fitting procedure:
- Cut a round hole of 165 to 170mm in the ceiling.
- Wire the speaker line to the terminals for the power and voltage you need.
- Fold the two spring clips, push the speaker into the hole and release them; wear gloves to protect your fingers.
- Check that the speaker sits firmly.
How many DSP6011 speakers per amplifier?
Add up the tap settings on the line, then leave some headroom. A mosque with 16 speakers at 6W draws 96W, so a 100V amplifier of 120W or more covers it. On a 70V system, side offices can drop to 3W to halve their load. Planning taps this way lets you size zones before you buy the amplifier.
Where the DSP6011 is used in Saudi Arabia
- School PA: one speaker per classroom and corridor for announcements and class bells.
- Mosques and company prayer rooms: the imam's voice and sermons inside the prayer hall.
- Offices and clinics: staff paging and quiet background music.
- Malls, supermarkets and sports halls.
- Residential compounds and reception areas.
DSP6011 vs DSP6011L vs DSP5211W
The DSP6011L uses the same driver, size and acoustic figures (6W, 90dB, 110Hz to 15kHz, 165 to 170mm cutout), but it is an 8 ohm model and DSPPA lists no 100V line rating for it, so it pairs with a low-impedance amplifier and a small number of speakers. Choose the DSP6011 for any 100V PA system with many speakers and long cable runs. For music with crisper treble in a restaurant or lounge, the DSP5211W is a 10W coaxial model.
Frequently Asked Questions
What cutout does the DSP6011 need?
A round hole of 165 to 170mm; the speaker locks in with spring clips.
Does the DSP6011 work with a 100V amplifier?
Yes. Its built-in transformer runs at 6W on 100V lines and at 3W or 6W on 70V lines.
Is the DSP6011 suitable for a mosque ceiling?
Yes. It is a 100V ceiling speaker that suits the imam's voice and sermons in the prayer hall; the number of speakers and amplifier size depend on the mosque's area.
Specifications
- Model: DSP6011
- Type: Frameless in-ceiling speaker
- Driver: 6.5 in
- Rated power (RMS): 6W
- Rated voltage / taps: 70V (3W / 6W), 100V (6W)
- Sensitivity: 90±2 dB
- Max SPL: 97±2 dB
- Frequency response: 110Hz to 15kHz
- Cutout: Ø165 to Ø170 mm
- Dimensions: Ø190.5 × 70 mm
- Net weight: 0.6 kg
- Materials: Engineering plastic housing, frameless aluminum grille
- Mounting: In-ceiling, spring clips
Features
- 70V/100V transformer: 3W or 6W on 70V, 6W on 100V, so dozens of speakers share one line.
- 165 to 170mm cutout and 70mm depth: fits most suspended ceilings, even with little void above.
- Spring clips: quick fitting once the hole is cut, with no extra brackets.
- 90±2dB sensitivity and 97±2dB max SPL: clear paging in a classroom or office from 6W.
- 0.6kg with a frameless aluminum grille: light on gypsum ceilings and nearly flush to the eye.
