DSPPA DMA2500 2x500W Two-Channel Mixer Amplifier for Mosques
3014.14ر.س
Product description
The DSPPA DMA2500 is a two-channel digital mixer amplifier rated 2x500W, which DSPPA says is optimized for mosque sound. It has 6 balanced mic inputs with 48V phantom power and built-in reverb, and also suits gyms, meeting rooms and large retail spaces.
====
The DSPPA DMA2500 is a two-channel digital mixer amplifier rated 2x500W, and DSPPA describes it as specially optimized for mosque sound. It brings the imam's mic, the muezzin's mic and wireless mics into one unit, then splits the output into two independently controlled channels: one for the prayer hall and one for outdoor speakers.
Why the DSPPA DMA2500 suits mosques
Domes and high walls bounce sound around, and speech gets muddy if reverb is not handled well. DSPPA built in a reverb processor with DOME, HALL and PLATE presets plus a DELAY mode with L, M or S room size. You can enable the effect on MIC5 and MIC6 only, and switch it on or off separately for the ROOM and OUTSIDE zones. The outdoor call stays crisp while recitation inside keeps some warmth.
Six mic inputs with individual phantom
The rear panel has 6 balanced XLR inputs, each paired with a 6.3mm jack. Every input has its own 48V phantom DIP switch, so a condenser mic at the mihrab and a dynamic mic for the muezzin can run side by side. Each mic channel also gets a 3-band EQ:
- LOW at 80Hz, ±12dB, to tame boominess.
- MID at 2.5kHz, ±12dB, for speech clarity.
- HIGH at 10kHz, ±12dB, for crisp consonants.
Two full-power channels, flexible outputs
Each channel is DIP-set to 100V or 70V constant voltage, or 8 or 4 ohm, and delivers full rated power in any mode. Run column speakers in the hall on a 100V line from CH1 and horn speakers on the minaret from CH2. MIC1 and the 3.5mm input can be set as priority inputs that mix in whatever mode is active. Each channel also has a REC OUT for recording sermons and lessons, PRE OUT and AMP IN jacks for inserting an external processor, and an AUX2 OUT pass-through that ignores the channel volume.
Remote control and lower standby power
A dedicated RJ45 port daisy-chains up to 6 DMA30W control panels, with up to 300 m per cable. The imam or muezzin can adjust both channels, switch zones and toggle reverb without walking to the equipment room. Add the optional DMA30N terminal for offline scheduled playback, an EMC dry contact and network audio. With standby enabled, the amplifier sleeps after 10 minutes of silence, dropping from 45W idle to 25W, and wakes as soon as a signal arrives.
Typical uses in Saudi Arabia
- Mosques and Friday mosques: hall channel plus outdoor channel.
- Prayer rooms in hospitals, universities and compounds.
- Gyms: music on one channel, announcements on the other.
- Meeting rooms and large stores, as DSPPA also recommends.
DMA2500 or DMA500U?
The DMA500U is a single 500W channel with USB, Bluetooth, FM, chimes and a siren trigger, outputting 4-16 ohm or 100V. The DMA2500 gives you two 500W channels, 6 mic inputs, built-in reverb, remote panels and a 70V option. Choose the DMA2500 for a mosque that needs inside and outside kept separate, and the DMA500U for a single paging and music zone.
Frequently Asked Questions
Can I keep the prayer hall and outdoor speakers separate?
Yes. It has two independent 500W channels, each with its own volume, and reverb can be enabled separately for the ROOM and OUTSIDE zones.
How many remote panels can I connect?
Up to 6 DMA30W panels on the dedicated RJ45 port, with a maximum of 300 m per cable.
Specifications
- Model: DMA2500
- Family: DMA2240 / DMA2500 two-channel digital mixer amplifier
- Output power: 2 × 500W
- Output modes per channel: 100V/70V constant voltage or 8Ω/4Ω, DIP-selectable at full rated power
- Microphone inputs: 6 (MIC1-6), balanced XLR plus unbalanced 6.3mm each, individual volume
- Phantom power: 48V per mic input, DIP switch
- AUX inputs: AUX1 3.5mm stereo (front); AUX2 RCA pair split to CH1/CH2 with independent volume
- Line I/O: AMP IN1-2 and PRE OUT1-2 (RCA), AUX2 OUT1-2 pass-through, REC OUT and BUS OUT per channel
- Priority: 3.5mm input and MIC1 can be set as priority inputs
- Reverb: DOME, HALL, PLATE, DELAY; room size L/M/S/OFF; adjustable depth and time; EFFECT on/off for MIC5-6 and OUTSIDE/ROOM zones
- Mic EQ: LOW 80Hz ±12dB, MID 2.5kHz ±12dB, HIGH 10kHz ±12dB
- AUX1 / AUX2 sensitivity: 250 ±25mV
- MIC1-6 sensitivity: Max 5 ±1mV, min 250 ±25mV
- Frequency response: AUX: 80Hz-16kHz; MIC: 100Hz-10kHz (±3dB)
- SNR: ≥76dB
- Noise: ≤8.5mV
- THD: ≤1%
- Line outputs CH1-2: BUS OUT, REC OUT, PRE OUT at 1 ±0.1 (100V mode)
- Remote control: RJ45 for up to 6 DMA30W panels (max 300 m per cable); RJ45 for one DMA30N
- DMA30N terminal (optional): Network audio decoding, offline scheduled playback, EMC dry contact, network AUX OUT
- Standby: After 10 min without audio (DIP switch), wakes on signal
- Power consumption: 45W idle, 25W energy-saving mode
- USB: Service port for firmware upgrades
- Power supply: AC 110-240V / 50Hz
Features
- 2x500W channels, each DIP-set to 100V, 70V, 8 ohm or 4 ohm: one channel for the prayer hall, one for outdoor speakers, both at full power.
- 6 balanced XLR mic inputs with per-input 48V phantom: imam, muezzin and wireless mics on one amplifier.
- Built-in reverb with DOME, HALL, PLATE and DELAY modes: clearer speech under a dome without an external processor.
- 3-band EQ on MIC1-6 (80Hz, 2.5kHz, 10kHz, ±12dB): shape each microphone to the person using it.
- Up to 6 DMA30W remote panels on cable runs up to 300 m: control volume and channels from the mihrab or the muezzin room.
