DSPPA DSP154H 15W Outdoor Horn Speaker with 70V/100V Taps
240.44ر.س
Product description
The DSPPA DSP154H is a compact aluminum paging horn rated at 15W on a 100V line, with a built-in 70V/100V transformer. It suits school yards, car parks and warehouses where announcements must carry over background noise.
====
The DSPPA DSP154H is a small, weatherproof horn speaker for outdoor paging. It delivers up to 15W on a 100V line, has a built-in 70V/100V transformer and an aluminum body that measures 195×195×250 mm and weighs 1.7 kg. Mount it on a wall or pole wherever announcements need to carry across open ground: school yards, car parks, loading bays and factory walkways.
DSPPA DSP154H specifications at a glance
All figures below come from DSPPA's product page and datasheet:
- Rated power: 15W (100V line).
- Frequency response: 400Hz to 8kHz.
- Sensitivity: 105±2 dB.
- Maximum SPL: 117±2 dB.
- Water resistance: IPX6.
Three power taps on one transformer
The transformer has three taps. On a 100V line you choose 4W, 8W or 15W; on a 70V line the same taps give 2W, 4W or 8W. In practice this lets you balance a whole site from one amplifier: set the horn beside the admin block to 4W and the one at the far end of the playground to 15W. DSPPA notes that high-voltage, low-current 70V/100V distribution cuts cable losses over long runs and lets many speakers share one line in parallel.
Tuned for voice, not music
A 400Hz to 8kHz response covers the range of human speech. Names, safety messages and shift announcements stay intelligible over traffic and wind noise. The trade-off is limited bass, so if the same area also needs background music, a wider-range model is the better choice.
Built for outdoor installation
The housing is high-quality aluminum that DSPPA says keeps its shape over years of use, and the IPX6 rating protects against powerful water jets. A mounting bracket is supplied. Fix three Φ8mm screws, hang the speaker, wire the line to the tap you need, then aim the horn at the target zone and check that it sits firmly.
Typical uses in Saudi Arabia
- School grounds: morning assembly, student calls and class bells as part of a school PA system.
- Hospital and mall car parks: short announcements and visitor directions.
- Warehouses and plants in industrial cities: staff paging and shift-change alerts.
- Farms and istirahas: calls across the yard or between buildings.
Amplifier compatibility
Any amplifier with a 70V or 100V line output will drive the DSP154H. Add up the tap settings of every speaker on a zone and pick an amplifier rated above that total, with some headroom. Ten horns on the 15W tap, for example, need at least 150W.
DSP154H, DSP163HD or DSP162HD?
The DSP154H is the smallest of the three: 15W, 400Hz to 8kHz and 1.7 kg, built for speech. The DSP163HD is a two-way horn giving 13W on 70V or 25W on 100V, with a 200Hz to 15kHz response and a weight of 3.3 kg, so it handles background music as well as paging. The DSP162HD steps up to 25W/50W, 250Hz to 15kHz and 121 dB maximum SPL. Pick the DSP154H for medium-sized areas where clear voice matters most and the budget is tight.
Frequently Asked Questions
Is the DSP154H rainproof?
Yes. DSPPA's product page lists an IPX6 rating, which covers powerful water jets, and the body is aluminum for outdoor mounting.
Can I use it with a standard 4 or 8 ohm amplifier?
DSPPA's datasheet lists 70V and 100V taps only, so pair it with an amplifier that has a 70V or 100V line output.
How many DSP154H horns can a 120W amplifier drive?
On the 15W tap the maths allows 8 horns, though leaving some headroom is wiser. On the 8W tap the count roughly doubles.
Specifications
- Model: DSP154H
- Type: Outdoor waterproof horn speaker
- Rated power: 15W
- Transformer: Built-in 70V/100V transformer
- Taps at 100V: 4W / 8W / 15W
- Taps at 70V: 2W / 4W / 8W
- Tap impedance: 2.5kΩ (4W@100V, 2W@70V), 1.3kΩ (8W@100V, 4W@70V), 660Ω (15W@100V, 8W@70V)
- Frequency response: 400Hz - 8kHz
- Sensitivity: 105±2dB
- Max SPL: 117±2dB
- Water resistance: IPX6
- Material: Aluminum
- Dimensions (L×W×H): 195×195×250 mm
- Weight: 1.7 kg
- Mounting: Supplied bracket, fixed with three Φ8mm screws
Features
- Three selectable taps: 4W, 8W or 15W on a 100V line (2W, 4W or 8W on 70V), so each horn gets the power its distance needs.
- 105±2 dB sensitivity and 117±2 dB max SPL: announcements carry across open ground from very little amplifier power.
- IPX6 water resistance: protected against powerful water jets on exposed walls and poles.
- 1.7 kg aluminum body: light on the bracket and, according to DSPPA, keeps its shape over long service.
- 400Hz to 8kHz response: tuned for speech, so names, alerts and bells stay intelligible.
