GENWEC Laser Hand Dryer

Components and Materials - The lid is made of 2 mm thick white steel (GW 01 25 03 00) or 2 mm thick AISI 304 stainless steel (GW01 25 04 01/GW01 25 04 02). Designed for high-traffic areas, the lid features a 360° rotating nozzle made of Zamak alloy. The nozzle includes a tamper-resistant protective mesh. The lid is secured to the mounting base using two tamper-proof fasteners. - The mounting base is made of 1.5 mm thick aluminum and has four 6 mm diameter mounting holes. It is equipped with four vibration-damping blocks to minimize hand dryer vibrations. - Motor - Universal motor with carbon brushes, operating at 220-240V, 5800 RPM, Class F. Equipped with an overheat protection switch. - Electronic Board - Fully shielded electronic board covered with an ABS housing. The infrared sensor sensitivity is adjustable. - Heating Element - Nickel/chromium (NiC) wire heating resistor with a mica foil housing, protected by an overheat protection switch. The element is not directly accessible. - Mounting Kit - Allen wrench for opening the cover, four 8mm Fischer wall plugs, and four 6mm screws. Operation: The infrared sensor automatically activates the dryer when hands are placed under the air outlet and within the sensor's detection range. Drying time is less than 25 seconds. The dryer stops operating when hands are removed from the sensor's detection range. The electronic sensor has an automatic shut-off function after approximately 60 seconds of operation if a stationary object is placed in front of the air outlet. After removing the fixed object, the electronic sensor automatically resets itself and the dryer resumes normal operation. Installation must follow the technical diagram provided in the technical data sheet or instruction manual. Four 8 mm diameter holes must be drilled to accommodate the included wall plugs (8 mm) and screws (6 mm), at the points indicated in the technical diagram. After securing the mounting bracket to the wall, the ground wire and sensor wire must be connected. Connect the wires.