GreatLife Dent the thermal forming vacuum laboratory previous dental vacuum forming casting machine dental covering machine previous for dentist

Thermal forming machine, dental laboratory, vacuum forming, dental vacuum casting, previous vacuum forming machine, specifications, type: vacuum forming and molding machine for teeth, voltage: 220V/50Hz ± 10%; 110V/60Hz ± 10%, power: 1000W, dimensions: 25*21*30 cm, weight: 6 kg, user manual, 1. The device with 220V/50Hz or 110V/60Hz, check the condition of the vacuum motor and electric heater. 2. Lift the top cover 90° (from the left or right side), place a layer between the upper and lower frame, and switch the handle to tightly close the frames. Turn the top cover back and push the high lock switch down to lift the frame to working position (there is a holder position on the main shafts). Then place the product in the middle of the sheet and turn on the heater to heat the film. Turn off the heater (after about 2-3 minutes), when the lower surface of the film under the mesh frame is about 1 cm. Switch the high lock switch to adjust the frame and turn on the vacuum motor, then remove the product after forming. The device structure below is for reference. 3. Method of use and application of the steel ball: The aluminum box is removed, the mold is set aside, then the steel ball is not needed to form the part for embedding, and the radio station is placed again. Scope of application: 1. Forming and producing color removal orthodontic appliances. 2. Removable orthodontic devices, arch molding, and plywood production. 3. Circulatory diseases, fluoride treatment, and production of molding trays. 4. Temporary and permanent bases for dental care in molding and production.