Infrared photoelectric reflection Intelligent car obstacle avoidance sensor Module

23

Product description

Infrared Reflective Smart Sensor Device Description: The sensor unit is adaptable to ambient light, with a pair of infrared emitting and receiving tubes, the transmitting tubes emit infrared radiation at a certain frequency, when an obstacle (reflection surface) is detected, the reflected infrared is received by the receiving tube, after processing by the comparator circuit, the green light is on, but the output interface outputs a digital signal (low level signal), you can adjust the detection distance with the potentiometer knob, the effective distance range is 2 to 30 cm, the working voltage is 3.3V - 5V. The sensor detection range can be obtained by adjusting the potentiometer, with little interference, easy assembly, user-friendly features, and can be widely used in robot obstacle avoidance, vehicle avoidance, line counting, black and white line tracking, and many other occasions. Factors: 1. When the unit detects an obstacle to the signal, the green indicator on the panel lights up, while the OUT port continues to output a low signal, the unit detects a distance of 2 to 30 cm, with a detection angle of 35 degrees, the detection distance can be adjusted by turning the potentiometer clockwise to increase the distance; counterclockwise to decrease the distance. 2. Active infrared reflection detection by the sensor, the reflection of the target and the shape is the critical detection distance, where the minimum detection distance is black, white, the maximum; small objects far from a small area, large objects in a large space. 3. The sensor module output port can be directly connected to the microcontroller IO and can also directly drive a 5V relay; connections: VCC-VCC; GND-GND; output IO. 4. LM393 comparators, stable. 5. The unit can be powered by 3-5V DC. When powered on, the red power indicator lights up. 6. Equipped with 3mm screw holes for easy fixed installation. 7. Panel size: 3.2cm * 1.4cm. 8. Each unit has a threshold comparison voltage adjusted by a good potentiometer; in non-special cases, the voltage cannot be adjusted. Module interface description: 1. VCC 3.3V-5V external voltage (can be directly connected to 5V and 3.3V MCU). 2. GND External GND. 3. OUT digital output interface for small board (0 and 1). Package contains: 50 x IR Infrared Obstacle Avoidance Sensor Module

Questions you might have

‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌