Liqui Moly Pro-Line Throttle Valve Cleaner 400ml

75

Out of Stock

Product description

Prepare your car engine activity and get rid of problems of weak torque and excessive fuel consumption. This advanced cleaner is specially designed to dissolve and remove the toughest deposits and dirt in the air intake (throttle) and intake passages, to give you smooth driving and a more efficient engine. Why choose this product? Deep and immediate cleaning: An active dissolving formula that breaks down oils, gums, glues, and stubborn combustion residues. Improve engine performance: Ensures smooth operation of moving parts and restores the engine’s quick response. Fuel saving: Removing deposits means better combustion and a noticeable reduction in gasoline consumption. Long-term protection: Enhances the reliability of gasoline engines and extends their lifespan. Comprehensive: Reaches fine openings and valves in the intake system. Compatibility: Exclusively designed for use in gasoline engines. Proper usage method to ensure effectiveness and safety, please follow the following steps carefully or watch the video above: Preparation: Disconnect the air hose to gain direct access to the air intake (throttle). Starting: Turn on the engine to begin the cleaning process. Technical note: If you cannot start the engine with the hose disconnected, or the engine does not maintain its rotation, disconnect the "Air Flow Meter" sensor and set the switch to OFF, then start the cleaning. (In this case, you should erase the recorded fault code with a diagnostic device after finishing, and reprogram the sensor if necessary). Spraying and cleaning: Spray the cleaner through the attached spray tube over the entire air intake area while the engine runs at a moderate speed (not less than 2000 RPM). Monitor the engine: If you notice fluctuations in engine speed (more than 1000 RPM) during spraying, reduce the spraying intervals (spray intermittently). Warning: Avoid contact of the cleaner with the air sensor (MAF) or coated parts. Final step: In case of severe deposits, repeat the process using a second can. After finishing, let the engine run for about 20 seconds at approximately 2000 RPM to burn off any remaining cleaner inside the intake system.

Questions you might have

‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌
‌
‌‌
‌