BESANTEK BST-MT297 Voltage and Continuity Tester
310.68ر.س
345.2ر.س-10%Product description
BESANTEK BST-MT297 Voltage and Continuity Tester
The BESANTEK BST-MT297 is a two-pole tester for checking AC and DC voltage between two points. Eight LEDs indicate voltage levels. It also provides audible continuity testing, polarity indication and phase rotation checks for electrical maintenance and troubleshooting.
Features
- Eight voltage indications with an audible signal and positive and negative polarity LEDs.
- Self-test and a built-in light for the test point.
- Interchangeable 2 mm and 4 mm probe tips, with 19 mm spacing in the paired position.
- Phase rotation and RCD trip testing as described in the manual.
Technical specifications
| Verified specifications |
| AC/DC voltage indication: 12–1000 V, with steps at 12, 24, 50, 120, 230, 400, 750 and 1000 V. |
| AC operating frequency: 40–65 Hz. Continuity range: below 200 kΩ. |
| Phase rotation test range: 100–1000 V between two phases under the manufacturer’s specified conditions. |
| IP65 enclosure. Measurement ratings: CAT III 1000 V and CAT IV 600 V per the datasheet. |
| Operating temperature: 0–40 °C at up to 80% RH. Power: two 1.5 V AAA batteries. |
| Dimensions: 248 × 68 × 34 mm. Approximate weight with batteries: 215 g. |
Package contents
Two-pole tester, batteries and instruction manual, per BESANTEK.
How to use
A qualified technician should run the self-test and verify operation on a known source as directed in the manual before relying on the indication. Isolate the circuit and verify absence of voltage before checking continuity. Observe the measurement category and voltage limits for the circuit.
Important Before Purchase
Match the measurement range, instrument function and required accessories to the task before ordering. Review the model manual, operating limits and connection method before use.
Frequently asked questions
How is voltage displayed? LEDs indicate the specified voltage steps.
Does it check polarity and continuity? Yes, it indicates polarity and provides an audible continuity signal within its range.
Recommended Products
- JADEVER 200 A AC Clamp Meter — For separate load current and voltage measurements during electrical troubleshooting within its ratings.
- JADEVER Non Contact AC Voltage Detector — For preliminary AC voltage detection near wiring; absence of an alert does not verify that a circuit is de energized.
- Three Level AC DC Voltage Tester — For probe based voltage level checks within the tester ratings and the applicable site procedure.
- KYORITSU KEW 3125A Insulation Tester — For insulation resistance testing at the voltage specified by the maintenance procedure, a separate function from voltage presence detection.
- WISEUP 16 Inch Tool Bag — To organize small inspection tools during transport; check internal dimensions before packing the instrument and accessories.

